2023 Updated 350-501 Tests Engine pdf - All Free Dumps Guaranteed!
Latest CCNP Service Provider 350-501 Actual Free Exam Questions
To prepare for the Cisco 350-501 exam, candidates can attend training courses, study relevant books and resources, and practice with lab equipment. Cisco also provides online resources and practice exams to help candidates prepare for the certification. Passing the exam requires a thorough understanding of the topics covered, as well as practical experience in working with service provider networks.
NEW QUESTION # 21
An engineer is implementing a router redistribution within BGP. The route map must be configured to permit all unmatched routes. Which action must the engineer perform to complete this task?
- A. Option A
- B. Option D
- C. Option C
- D. Option B
Answer: B
NEW QUESTION # 22
Which statement describes the advantage of a Multi-Layer control plane?
- A. It automatically provisions, monitors, and manages traffic across Layer 0 to Layer 3.
- B. It provides multivendor configuration capabilities for Layer 3 to Layer 1.
- C. It minimizes human error configuring converged networks.
- D. It supports dynamic wavelength restoration in Layer 0.
Answer: B
Explanation:
Section: Architecture
NEW QUESTION # 23
You are creating new Cisco MPLS TE tunnels. Which type of RSVP message does the headend router send to reserve bandwidth on the path to the tunnel's router?
- A. reservation
- B. tear
- C. error
- D. path
Answer: D
NEW QUESTION # 24
Refer to the exhibit.
An engineer wants to determine which paths are best, second best, third best, and fourth best. Drag and drop the peer addresses on the left to the corresponding BGP best-path selection order on the right.
Best - 50.50.50.2
2nd Best - 40.40.40.2
3rd Best - 20.20.20.2
44th Best - 30.30.30.2
Answer:
Explanation:
NEW QUESTION # 25
Refer To the exhibit:
On R1, which output does the show isis neighbors command generate?
- A. Option A
- B. Option D
- C. Option C
- D. Option B
Answer: A
NEW QUESTION # 26
Refer to the exhibit:
R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed. When the debug ip ospf hello command is issued on R1. these log messages are seen.
Which command can be configured on routers R1 and R2 on fO/O interfaces to form OSPF adjacency?
- A. ip ospf network point-to- multipoint non-broadcast
- B. ip ospf network point-to-point
- C. ip ospf network broadcast
- D. ip ospf network non-broadcast
Answer: B
NEW QUESTION # 27
Refer to the exhibit:
Which purpose of implementing NSF with this configuration is true?
- A. The router uses NSF to handle RP switchover while allowing neighbor relationships to remain up
- B. The router uses NSF to reduce neighbor-relationship downtime during RP switchover
- C. The router uses NSF to load balance traffic on a routed EtherChannel
- D. The router uses NSF to load balance traffic between two links, with the primary link alternating every
90 seconds
Answer: A
NEW QUESTION # 28
Drag and drop the functionalities from the left onto the target fields on the right.
Answer:
Explanation:
NEW QUESTION # 29
An engineer Is implementing NSR with OSPF on a large campus that requires high availability. Which task must an engineer perform to complete the process with minimal disruption to traffic?
- A. increase the keepalive interval on the OSPF neighbors so that traffic continues to pass during the switchover.
- B. Reset OSPF neighbor sessions to maintain state Information during router switchover
- C. Ensure that the dual RP has synchronized their state information before performing the switchover operation.
- D. Configure the device to repopulate state information using routing updates received from the BDR
Answer: C
NEW QUESTION # 30
What is the role of NFVI?
- A. domain name service
- B. intrusion detection
- C. network address translation
- D. monitor
Answer: D
NEW QUESTION # 31
Refer to the exhibit:
Which two statements about the ISIS topology are true? (Choose two.)
- A. R1 and R2 are Level 2 neighbors.
- B. All four routers are operating as Level 1-2 routers.
- C. All four routers are operating as Level 2 routers only.
- D. R1 and R4 are Level 2 neighbors
- E. All four routers are operating as Level 1 routers only.
Answer: A,B
NEW QUESTION # 32
Which type of attack is a protocol attack?
- A. Slowloris
- B. TFTP flood
- C. HTTP flood
- D. SYN flood
Answer: D
Explanation:
NEW QUESTION # 33 
Refer to the exhibit. Which type of DDoS attack will be mitigated by this configuration?
- A. teardrop attack
- B. SIP INVITE flood attacks
- C. SYN flood
- D. smurf attack
Answer: D
Explanation:
Section: Architecture
NEW QUESTION # 34
Refer to the exhibit:
An engineer is preparing to implement data plane security configuration.
Which statement about this configuration is true?
- A. Router 2 must configure a route to null 0 for network 192 168.1 0/24 for the RTBH implementation to be complete.
- B. Router 1 is the trigger router in a RTBH implementation.
- C. Router 2 is the router receiving the DDoS attack
- D. Router 1 must be configured with uRPF for the RTBH implementation to be effective.
Answer: B
NEW QUESTION # 35
Refer to the exhibit. An engineer applied a gRPC dial-in configuration on customer's router to provide connection multiplexing and two-way streaming.
What does this configuration accomplish in a gRPC?
- A. It is used for encoding with the default protocol buffers
- B. IT is the encoding that is used for dial-in and dial-out.
- C. It is the encoding requested by the gRPC server.
- D. It is the encoding requested by the gRPC client.
Answer: C
NEW QUESTION # 36
Refer to the exhibit.
- A. to 2.2.2.2, with a TTL of 2 or more
- B. from 2.2.2.2, with a TTL of less than 2
- C. from 2.2.2.2, with a TTL of 253 or more
- D. to 2.2.2.2, with a TTL of less than 253
Answer: B
NEW QUESTION # 37
Refer to the exhibit:
An engineer is preparing to implement link aggregation configuration.
Which statement al about this configuration is true?
- A. The switch port actively sends packets to negotiate an EtherChannel using PAgP
- B. The switch port negotiates an EtherChannel if it receives LACP packets from a connected peer
- C. The switch port passively negotiates an EtherChannel if it receives PAgP packets from a connected peer
- D. The switch port accepts LACP and PAgP packets from a connected peer and negotiate an EtherChannel using the common EtherChannel mode.
Answer: A
NEW QUESTION # 38
Drag and drop the functionalities from the left onto the correct target fields on the right.
Answer:
Explanation:
NEW QUESTION # 39
Which protocol does a Cisco MPLS TE tunnel use to maintain paths within the core?
- A. STP
- B. VTP
- C. RSVP
- D. RPF
Answer: C
NEW QUESTION # 40
Refer to the exhibit.
An engineer wants to determine which paths are best, second best, third best, and fourth best. Drag and drop the peer addresses on the left to the corresponding BGP best-path selection order on the right.
Answer:
Explanation:
NEW QUESTION # 41
You are writing an RPL script to accept routes only from certain autonomous systems Consider this code.
If you apply this code to BGP filters, which effect does the code have on your router?
- A. allows routes from AS 770
- B. allows routes from AS 7077
- C. denies routes from AS 7070
- D. denies routes from AS 7007
Answer: B
NEW QUESTION # 42
Drag and drop the methods of Cisco MPLS TE tunnel traffic assignment from the left onto their characteristics on the right.
Answer:
Explanation:
NEW QUESTION # 43
A network engineer must configure a router for Flexible NetFlow IPFIX export. The IP address of the destination server is 172.17.12.1. The source address must be set to the Loopback0 IPv4 address and exported packets must be set to DSCP CS3. The TTL must be 64 and the transport protocol must be set to UDP with destination port 4739. Which configuration must the engineer apply to the router?
- A. configure terminal
flow exporter EXPORTER-1
destination 172.17.12.1
source Loopback0
dscp 3
ttl 64
export-protocol ipfix
end - B. configure terminal
flow exporter EXPORTER-1
destination 172.17.12.1
source Loopback0
dscp 3
ttl 64
export-protocol netflow-v9
transport udp 4739
end - C. configure terminal
flow exporter EXPORTER-1
destination 172.17.12.1
source Loopback0
dscp 24
ttl 64
export-protocol netflow-v9
transport udp 4739
end - D. configure terminal
flow exporter EXPORTER-1
destination 172.17.12.1
source Loopback0
dscp 24
ttl 64
export-protocol ipfix
end
Answer: D
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/fnetflow/configuration/xe-3s/fnf-xe-3s-book/fnf-ipfix-export.html#d27853e197a1635
NEW QUESTION # 44
......
How to study the Cisco 350-501: Implementing and Operating Cisco Service Provider Network Core Technologies Exam
For the Implementing Cisco Service Provider VPN Services (Cisco 350-501) Exam, Cisco offers several options on their website. Cisco provides classroom training through which Cisco's authorized learning partners teach instructor-led classes all over the world. E-Learning solutions are provided by Cisco for exam preparation via self-paced online courses. Students are highly encouraged to join Cisco's Certification community where they can join students from all over the world and learn together. After taking all the official training courses, 350-501 practice exams are a must to get a proper understanding of exam format and question types.
We recommend a combination of hands-on experience, completion of the training course, and self-study in the areas described in the Exam Outline section of this exam guide as preparation for this exam.
Hover on to Cisco's Website and complete the official training course provided for the exam. Check for the topics mentioned in the Exam Outline section of this guide, see the 350-501 exam dumps, review the online documentation, tip sheets, and user guides and study the details relevant to those topics. Refer to the links at the end of this document for more study material.
The Cisco 350-501 SPCOR exam focuses on testing the candidates’ skills in operating and implementing Cisco Service Provider Network Core Technologies. This exam is necessary to obtain different certifications such as the Cisco Certified Specialist – Service Provider Core accreditation, as well as CCIE Service Provider and CCNP Service Provider certificates.
350-501 Dumps Updated Practice Test and 373 unique questions: https://prep4sure.dumpsfree.com/350-501-valid-exam.html